Rectifier / diode board for Bosch charging systems. High quaility replacement part sourced from Germany

See our Bosch fault finder page for help diagnosing problems on your Bosch charging system.

 This part is due back in stock soon, call 01484 841395 to reserve yours

17704300-z 17704300 GU17704300 17 70 43 00
 1770 4300 1770.4300 17.70.43.00

3 pin plastic connector for headlight bulb spade connections

No longer available from Guzzi

 Sorry, this part is no longer available.

 17740364 GU17740364 17 74 03 64
 1774 0364 1774.0364 17.74.03.64

Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils

Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit

 This part is due back in stock soon, call 01484 841395 to reserve yours

Marelli phase sensor for Digiplex ignition and tacho

2 pin block connector

 This part is available by special order, request a quote

 20721610 GU20721610 20 72 16 10
 2072 1610 2072.1610 20.72.16.10

Motoplat ignition unit for one cylinder (2 required per bike)

Also known as Guzzi ref. 23721493, 27721435, 23721491, 23721490, 27721435

 This part is available by special order, request a quote

 23721494 GU23721494 23 72 14 94
 2372 1494 2372.1494 23.72.14.94

Protective cap for battery lead

 This part is due back in stock soon, call 01484 841395 to reserve yours

25707100-z 25707100 GU25707100 25 70 71 00
 2570 7100 2570.7100 25.70.71.00

Push button starter switch, chrome finish body, screw contacts to rear

 This part is available by special order, request a quote

26735001-z 26735001 GU26735001 26 73 50 01
 2673 5001 2673.5001 26.73.50.01

12 volt single output 3 Ohm ignition coil (lead to distributor)

Push fit HT lead, see ELA00001 for crimp on HT lead connector. Supplied without coil clamp

 This part is due back in stock soon, call 01484 841395 to reserve yours

 26716504 GU26716504 26 71 65 04
 2671 6504 2671.6504 26.71.65.04

Complete right hand Domino switchgear (starter and kill switch) plus twistgrip and pair of handlebar grips

Supplied with 4 pin Molex type connector. Use with ELA27015 to replace earlier Lego switch gear from Le Mans 2, T3 and V50 era models. No longer in production

 Sorry, this part is no longer available.

 27738815 GU27738815 27 73 88 15
 2773 8815 2773.8815 27.73.88.15

Brakelight switch (microswitch) with 2 pin lead

Also see ELA30860

 Availability varies on this part, check availability

 27749815 GU27749815 27 74 98 15
 2774 9815 2774.9815 27.74.98.15